Date
Event Location
2219EB

ELECTRICAL AND COMPUTER ENGINEERING SEMINAR SERIES

Dr. Daniel Hines

Laboratory for Physical Sciences

University of Maryland

Thursday, August 23, 2018

10:00 a.m. – 11:00 a.m.

2219 EB

“Toward the Fabrication of Electronic Circuits without using Surface Mounted Components”

Abstract:

Conventional electronic circuits consist of surface mounted components containing bare IC chips internally wire-bonded to the lead-frame of a package which is then solder-connected onto circuitization a printed circuit board (PCB). Direct-write printing methods offer the opportunity to additively fabricate the circuitization and interconnects needed to replace wire-bonds and solder connected packages.  Electrical interconnects can be printed directly onto the pads of a bare IC chip and seamlessly connected to circuitization that can also be fabricated using the same direct-write printing methods.  Furthermore, other circuit components such as resistors, capacitors and inductors can be fabricated and/or connected to printed circuitization using similar methods.  The fabrication of such printed hybrid electronics (PHE) requires the ability to direct-write print both circuitization and interconnects along with creating smooth transitions onto and off different surfaces containing the needed electrical connections. Such smooth transitions between surfaces at different levels can be fabricated by printing a structural feature (referred to as a fillet) along the edge of the bare die. It is also possible to fabricate resistors, inductors and capacitors.  The fabrication of all of these features and devices requires the ability to precisely print a known and controllable volume of material at specific positions. The fabrication of structural features will be presented and discussed in detail. The fabrication of circuit components that can be embedded /integrated into the fabrication of direct-write printed electronic circuits will also be presented.

Bio:
Dr. Daniel Hines obtained an MS in Physics from Michigan State University and a Ph.D. from the University of Maryland.  Prior to coming to the Laboratory for Physical Sciences (LPS) in 2003, he worked at Schumberger's research center in Ridgefield, CT and at the NEC Research Institute (NECI) in Princeton, NJ.  At LPS, he initially developed transfer printing techniques used to fabricate high quality organic and carbon-based thin-film transistors on plastic substrates.  Since 2012, he has been developing additive manufacturing methods for the fabrication of printed hybrid electronics.

Faculty Host:  Dr. Lee Harle (harle@egr.msu.edu)

Michigan State University is committed to providing equal opportunity for participation in all programs, services and activities.  Accommodations for persons with disabilities may be requested by contacting Dr. Cagri Ulusoy (Ulusoy@msu.edu)